Factory Reconditioned Ryobi ZRRY10532 18-Inch 40cc 2-Cycle Gas-Powered Chain Saw

I received the unit today and put the chain on, added fuel, and chain oil. The unit had sawdust inside the unit and overall not very clean, this does not seem to fit reconditioned description, more like used. It took me awhile to get it started probably because gas and oil were drained and was hard to start hopefully it will be fine.
Now the reason I left feedback here is even following instructions from Amazon I can't seem to find how to get additional information on the product such as warrenty info and service and perhaps let them know the overall condition of the unit in case of any problems.

When I first opened the box, I was impressed that they had included a brand new chain bar and chain with this refurbished saw. However, after I put the saw together and started it up, my opinion changed. The flywheel rubs against the inside of the housing - it actually rubbed a thin strip of metal off of it and gouged the inside of the housing. I figured, no problem, I'll return it. I soon found out Amazon does not let you return gas powered items (funny, they had no problem shipping it w/ gas and oil in it). Lesson learned- read the small print on Amazon, or better yet, don't buy anything with moving parts.

I bought one from CPO as a reconditioned unit. Came with bar, chain, manual and bar-tool. Did not come with case or other accessories. First time I tried to run it, it spit solvent from the muffler and ran way too rich (fat). So I ordered the "Double D" carb adjusting tool from Randys Small Engines.

In about a week I had my tool and set about getting it right. Fired it up and turned the high speed down jet to about 1 3/4 turns and low speed down to just under 1 1/2 turns. Runs fine now. Has good power, but likes to wind. If you load it too hard it will bog. This same motor is used by the RC Model Plane folks. It's made by Zenoah.

Comes stock with Carlton semi-chisel chain and that's a pretty aggressive chain, so it can load the motor pretty easily. Might have been better to put a VG style chain on it, but that's what it comes with. If you just let the saw do the cutting and don't lean on it at all, it'll plow through most anything. I have cut 3...Read more